Glass enamel coloring material

Several of the potential hazardous ingredients (listed in section 2) have been chemically reacted at high temperatures and are homogeneously and ionically interdiffused to form essentially insoluble pigment crystals with a crystalline matrix of spinel. This means they do not necessarily have any of the properties of its component oxides or metals. Long term inhalation of silica dust or mist over an extended period of time may result in injury to the lungs or silicosis. Chronic exposure to cobalt compounds may affect kidneys, lungs or thyroid.

If inhaled, move affected individual to fresh air. In case of eye contact, rinse thoroughly with water for at least 15 minutes. Hold eyelids apart to insure rinsing of the entire eye surface and lids with water. In ingested, give at least 3-4 glasses of water, but do not induce vomiting. For skin contact irritation, wash affected area with plenty of water and soap, for several minutes. Seek medical attention if irritation persists.

Non-Flammable. No polymerization. Material is stable. Firefighters should wear self-contained breathing apparatus and full protective clothing when fighting chemical fires.

Uncontaminated material may be recovered and used, otherwise clean up with paper towels and dispose of in trash receptacle. Avoid generation of dust. Do not flush into surface water or sanitary sewer system.

Close lid tightly. Store in dry area. Avoid contact with eyes and clothing. Use adequate ventilation. Wear suitable gloves, glasses and face protection. Minimize dust generation during handling. If spraying, use NIOSH approved respirator for dust and mist is required. Practice good housekeeping.

Use adequate ventilation. Wear safety glasses and gloves as needed. Use a NIOSH certified (or equivalent) particle respirator when handling powders or when dust may become airborne.

Appearance: Colored powder or liquid, depending on product. Odor: None or mild. Solubility: Varies by product. Flash Point: Not applicable unless specified.

Stable under recommended storage and handling conditions. Chemically stable. Incompatible with acids, strong ammonium compounds, reducing agents. Avoid incompatible materials and unnecessary dust generation. No reactivity.

May cause eye irritation, skin irritation, and respiratory tract irritation. Product may be abrasive to skin and eyes. Prolonged or repeated inhalation of respirable silica-containing dust or mist over extended periods may result in lung injury, including silicosis. This product may contain crystalline silica, which is classified by IARC as a suspected human carcinogen when inhaled in respirable form over prolonged periods. No known skin or respiratory sensitization effects.

No specific ecological data available. Avoid release into waterways or the environment.

Dispose of contents and container in accordance with local, state, and federal regulations.

Protect against physical damage. TDG: UN1500 – for pure NaNO3 compounds – these products may or may not have <5%. DOT: UN1500 – for pure NaNO3 compounds – these products may or may not have <5%. (49 CFR 172.101) This is not a hazardous material as classified by CFR 172.101

Regulatory status should be reviewed based on final product composition and jurisdiction.

Other CAS numbers: 68187-15-5 1344-00-9 68187-12-2 66402-68-4 112945-52-5 68186-97-0